Photographers can use the WR-1 to simultaneously release the shutter on multiple Nikon D-SLR cameras that have a WR-R10 and/or WR-1 units attached and have been paired with it. Likewise, the WR-1 can be used as a transceiver, to be controlled by a WR-T10 that is paired with it. The WR-1 is compatible with the WR-T10 & R10 as long as the WR-1 is set to Group A as the WR-R10/WR-T10 system is fixed on Group A.
The WR-1 has access to 15 radio frequency channels (1-15), to prevent interference when multiple pairings or photographers are shooting in one location. Using the WR-1 display, you can even visualize the traffic in each of the 15 channels and select the one with the least amount of traffic to minimize interference.
The WR-1 can be designated as a “master” and control the shutters of up to 20 WR-1 units, or 64 WR-R10 units. The WR-1 is compatible with the WR-T10 & R10 as long as the WR-1 is set to Group A as the
WR-R10/WR-T10 system is fixed on Group A.
When using the release delay mode on the WR-1 transceiver, different delays can be used for different receivers, allowing the shutter release to be staggered over a series of cameras using a single transmitter.
When using a WR-1 as a transmitter and another as a transceiver, a third WR-1 unit can be used as a relay unit to effectively double the distance (line of sight) to the same 394 ft between units.
When connected to a D4, D800/D800E, D600, D5200 or D7100 D-SLR, the Fn button on the WR-1 has full control of the features that the camera’s Fn button controls.
Comes with a soft case, MC-37 Connecting Cord (for ten-pin remote terminals) and MC-38 Connecting Cord (for accessory terminals).
|Name||Nikon - WR-1 Wireless Remote Control|
|Manufacturer Part No||NI-27115|