Happily Serving You in the Same Location for Over 58 Years!

Welcome!

Focusers

Items 81 to 100 of 206 total

per page
Page:
  1. 5

Set Ascending Direction
  1. RoboFocus - RF3 Van Slyke

    RoboFocus - RF3 Van Slyke

    Van Slyke Engineering, (and other focuser manufacturers), obtains the RF3 motor directly from Technical Innovations and build into focuser as requested ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: RF3V
    $335.00

  2. RoboFocus - RF3 Upgrade

    RoboFocus - RF3 Upgrade

    Owners of earlier Model 1 and Model 2 RoboFocus control units can have these devices upgraded to version 3.1 at a fixed cost. This upgrade includes the replacement of 3 IC chips, new firmware and two circuit board upgrades ... Learn More
    Model#: RFU
    $35.00

  3. RoboFocus - RF3 International

    RoboFocus - RF3 International

    Complete RoboFocus system, ready to install and operate on your specific telescope/focuser. System includes custom designed stepper motor, RF3 control module, mounting hardware (brackets, shaft coupler, and/or timing sprocket), 2 ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: RF3I
    $495.00

  4. RoboFocus - RF3 Controller

    RoboFocus - RF3 Controller

    The RoboFocus control module can be purchased separately as a backup unit or to combine with an additional motor kit that was previously obtained.

    ...
    Learn More
    FREE SHIPPING
    (48 States)
    Model#: RFC
    $330.00

  5. RoboFocus - LX200 8 GPS Bracket

    RoboFocus - LX200 8 GPS Bracket

    Custom bracket for the LX200 8" GPS. With the mirror lock knob and handle on the smaller rear plane of this scope, there is no surface room available for traditional SCT mounting. This bracket raises the motor assembly up and over the handle, allowing the sprocket and belt to install on the top area of the focus knob.

    ...
    Learn More
    Model#: RFB5
    $35.00

  6. RoboFocus - JMI DX1/DX2 Bracket

    RoboFocus - JMI DX1/DX2 Bracket

    Custom bracket for JMI DX1 and DX2 focusers. Bracket is made with 0.125 aluminum with an attractive black powder coat finish. The bracket is very stable and designed for fast and easy RoboFocus motor mounting.

    Note: Two holes must be drilled in the focuser housing base. TI will drill and mount bracket at no charge if desired.

    ...
    Learn More
    Model#: RFB4
    $35.00

  7. RoboFocus - Hand Paddle

    RoboFocus - Hand Paddle

    The RF3 Hand Paddle allows manual focusing via a small hand controller on a 12 foot cable. The "in/out" buttons move the stepper motor to achieve visual focus. These buttons are duplicates of the ones on the RoboFocus controller box.

    ...
    Learn More
    Model#: RFHP
    $30.00

  8. RoboFocus - AP Bracket

    RoboFocus - AP Bracket

    Custom bracket for Astro Physics focusers. This bracket is designed for both the 2 and 4 inch focusers. It is made with 0.125 aluminum with an attractive black power coat finish. The bracket is very stable and designed for fast and easy RoboFocus motor mounting.

    ...
    Learn More
    Model#: RFB1
    $35.00

  9. QSI - WSG Focus Adjustment Disk

    QSI - WSG Focus Adjustment Disk

    This 0.225" (5.6mm) optical disk can be placed between some guide cameras (e.g. Orion SSAG) and the T-mount Guide Camera Adapter to allow the guide camera to acheive critical focus parfocal with the main sensor.

    ...
    Learn More
    Model#: AC5-WSG-FAD
    $10.00

  10. PlaneWave - Integrated Rotating Focuser

    PlaneWave - Integrated Rotating Focuser

    The IRF90 is a large capacity Integrated Focuser and Rotator. The Focuser is capable of lifting 40 lbs (18 kg) with a range 30 mm (30000 microns). The Rotator has a 90mm aperture with a range of 365 degrees with hardstops to elliminate any chance of cord wrap.

    ...
    Learn More
    Model#: 600180
    $4,500.00

  11. PlaneWave Hedrick Focuser

    PlaneWave - Hedrick Focuser

    The Hedrick focuser designed by PlaneWave is a heavy duty no-slip focuser capable of handling a imaging payload of up to 20lbs.

    ...
    Learn More
    Model#: 200340
    $1,000.00

  12. PlaneWave - Electronic Focus Accessory for CDK 20" OTA

    PlaneWave - Electronic Focus Accessory for CDK 20" OTA

    The EFA Kit automates focusing, temperature monitoring, control of accessories and control of fans. The kit comes complete with a 12VDC servo motor, motor mounting bracket and a set of bevel gears.

    ...
    Learn More
    Model#: 200901
    $800.00

  13. PlaneWave - Electronic Focus Accessory for CDK 17" OTA

    PlaneWave - Electronic Focus Accessory for CDK 17" OTA

    The EFA Kit automates focusing, temperature monitoring, control of accessories and control of fans. The kit comes complete with a 12VDC servo motor, motor mounting bracket and a set of bevel gears.

    ...
    Learn More
    Model#: 240901
    $1,000.00

  14. PlaneWave - Electronic Focus Accessory for CDK 12.5" OTA

    PlaneWave - Electronic Focus Accessory for CDK 12.5" OTA

    The EFA Kit automates focusing, temperature monitoring, control of accessories and control of fans. The kit comes complete with a 12VDC servo motor, motor mounting bracket and a set of bevel gears.

    ...
    Learn More
    Model#: 125901
    $800.00

  15. PetersonEng - EZ Focus Kit

    PetersonEng - EZ Focus Kit

    his kit is intended for use with all Meade 7" through 12" Schmidt-Cassegrain and Maksutov-Cassegrain telescopes - including the LX200GPS, the LX200 Classic, the LX90, the LX50 and the LX10 ... Learn More
    Model#: EZFocusKit
    $29.99

  16. Optec - TCFS-3i 3" Integrated Temperature Compensating Focuser Kit.

    Optec - TCFS-3i 3" Integrated Temperature Compensating Focuser Kit.

    The TCF-S has a new big brother - the TCF-S3. This 5 pound focuser has all the same features of the TCF-S but is just bigger and stronger ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: TCF-S3i
    $1,795.00

  17. Optec - TCF-Si Integrated Temperature Compensating Focuser Kit.

    Optec - TCF-Si Integrated Temperature Compensating Focuser Kit.

    Heavy-duty Crayford style 2" focuser Compensates for focal shift due to temperature Supports instruments up to 10 pounds Easy to use control box Use with or without a PC 4-digit readout for position Simple Learn procedure for determin ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: TCF-Si
    $795.00

  18. Optec - TCF-S Temperature Compensating Focuser Kit.

    Optec - TCF-S Temperature Compensating Focuser Kit.

    Heavy-duty Crayford style 2" focuser Compensates for focal shift due to temperature Supports instruments up to 10 pounds Easy to use control box Use with or without a PC 4-digit readout for position Simple Learn procedure for determing ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: TCF-S
    $1,000.00

  19. Optec - TCF-S 3" Temperature Compensating Focuser Kit.

    Optec - TCF-S 3" Temperature Compensating Focuser Kit.

    The TCF-S has a new big brother - the TCF-S3. This 5 pound focuser has all the same features of the TCF-S but is just bigger and stronger ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: TCF-S3
    $2,000.00

  20. Optec - TCF-Lynx3, 3” Temperature Compensating Focuser with FocusLynx Controller

    Optec - TCF-Lynx3, 3” Temperature Compensating Focuser with FocusLynx Controller

    TCF-Lynx3 focuser with FocusLynx control system includes 3-inch Crayford style focuser, FocusLynx controller, 20-inch long temperature probe, power supply, 7-ft. Cat-5e cable and ... Learn More
    FREE SHIPPING
    (48 States)
    Model#: 19706
    $1,795.00

Items 81 to 100 of 206 total

per page
Page:
  1. 5

Set Ascending Direction