You can elect to use your RoboFocus system on a second telescope by purchasing and installing an additional motor. The Additional Motor Kit comes with a stepper motor and mounting hardware, (brackets, shaft coupler, and/or timing sprockets and belts).

You must specify telescope/focuser that the system will be installed on. In some cases we may need to contact you for further information

Custom bracket for Astro Physics focusers. This bracket is designed for both the 2 and 4 inch focusers. It is made with 0.125 aluminum with an attractive black power coat finish. The bracket is very stable and designed for fast and easy RoboFocus motor mounting.

The RF3 Hand Paddle allows manual focusing via a small hand controller on a 12 foot cable. The "in/out" buttons move the stepper motor to achieve visual focus. These buttons are duplicates of the ones on the RoboFocus controller box.

Custom bracket for JMI DX1 and DX2 focusers. Bracket is made with 0.125 aluminum with an attractive black powder coat finish. The bracket is very stable and designed for fast and easy RoboFocus motor mounting.

Note: Two holes must be drilled in the focuser housing base. TI will drill and mount bracket at no charge if desired.

Custom bracket for the LX200 8" GPS. With the mirror lock knob and handle on the smaller rear plane of this scope, there is no surface room available for traditional SCT mounting. This bracket raises the motor assembly up and over the handle, allowing the sprocket and belt to install on the top area of the focus knob.

The Remote Power Module is a convenient way for the user to control remotely up to four 120vAC (or 240vAC or 12vDC), outlets through the RoboFocus control program on the PC. Outlets can be connected to observatory accessories such as CCD cameras, heaters, dew zappers, video cameras, etc. Each outlet has its own pilot light. Removing source power to the module will reset all outlets to "OFF", while disconnecting from the control program software leaves each in its current state.

The RoboFocus control module can be purchased separately as a backup unit or to combine with an additional motor kit that was previously obtained.

Custom bracket for Takahashi rack-and-pinion focusers. This bracket is designed for both the 2 and 4 inch focusers. It is made with 0.125 aluminum with an attractive black power coat finish. The bracket is very stable and designed for fast and easy RoboFocus motor mounting.

Custom bracket for Takahashi "new Q" and ED180 rack-and-pinion focusers. This bracket is designed for both the 2 and 4 inch focusers. It is made with 0.125 aluminum with an attractive black power coat finish. The bracket is very stable and designed for fast and easy RoboFocus motor mounting.