Bobs Knobs - KNOBS FOR MEADE 16 inch f10 SCT WITH 6-SCREW SECONDARY

COLLIMATE YOUR SCHMIDT-CASSEGRAIN STYLE OR NEWTONIAN STYLE TELESCOPE WITHOUT TOOLS

It′s easy . . . just grab a Bob′s Knob and turn. You can even do it while looking
through the eyepiece on most scopes. And you′ll never drop that pesky little Allen wrench
or screwdriver into the grass again. Installation is a snap with the included instructions, and
you can undo the modification at any time.

Fits: All Meade 16 inch (41 cm) f/10 SCT versions with six screws on the secondary housing.
The inner screws are for collimation.

Knobs: Stainless steel, 19 mm (3/4 inch) diameter

Threads: Stainless steel

Note1: The factory dust cover will fit normally with Bob′s Knobs installed.

Note2: See our FAQ for additional information on installing Bob′s Knobs on Meade
telescopes with six factory secondary screws.

Note3: Earlier Meade 16 inch (41 cm) telescopes have three screws on the secondary
housing. These scopes require different knobs. Do not use knobs for the 3-screw secondary on the
6-screw secondary. The screws on these knobs are too long.

Note4: We will provide a free Allen wrench for removing the factory collimation screws
upon request. Put your request in the remarks section of your order, or send us an email with
your postal address and the model of your Meade SCT.